谁能指导下海盗船客服发来的K70固件更新

飞天蛙

客服发来：1 - Please completely exit out of the Corsair Utility Engine Software
2 - Disconnect the keyboard entirely from your system
3 - Using a paperclip, thumb tack, or thin needle, please hold down on the reset button located next to the polling rate switch
4 - As it is pressed down, please connect the keyboard to a USB 3.0 port on your system (please ensure the connector labeled with the keyboard icon is connected only)
5 - A file explorer pop-up (check file explorer if it doesn't) will be displayed showing drive name as CRP_DISABLED
6 - Please ensure you first delete the firmware.bin file that is on the CRP_DISABLED drive. Transfer the K70RGB_ISP_V205.bin that is attached to this ticket over to the CRP_DISABLED drive.
7 - Insert the keyboard as you normally would to have the keyboard initialize.


第四步是不是说按住恢复键的时候链接电脑USB3.0
然后连接了就没反应啊，第五部什么意思

光速空间

直接升级就行，不用什么按键